CBR-Forum.org.uk

Fri 18 Nov,2011 23:22

hiya just got CBR600f sport, no idea how to fit a scott oiler to fuel injection any help/ideas

Tue 25 Oct,2011 18:04

Hi just purchsed gilles rearsets for cbr600rr8 vcr38gt h02 any1 got any pics on or advise on mounting them 1 have 4 screws left 2sml and 2lagre and 3 sets of silver spaces s/m/l!!!

Mon 29 Aug,2011 04:16

Hi ive just joined and was wondering can anyone tell me if i can raise handle bars on cbr600f o4 model. and if yes how high,

Sun 21 Aug,2011 21:01

Hi,Ive got a CBR600RR4 I got last september stored it for the winter when I fired it up in spring the MIL was flashing 8 times my manual say's its the TP sensor ive had a mechanic test the voltages etc which all check out ok.I need to reset the MIL which the manual say's can be done by shorting two terminals on the DLC connector under the seat,however it doesn't say which terminals.some of the posts on here suggest that they are the green & brown but there are no green and brown wires to the DLC[data link connector.The bike runs fine and pulls well right through the rev range,any suggestions?

Sat 20 Aug,2011 14:25

Hi all. Only just joined. Ive just brought a cbr900rr fireblade 1999 t-reg. would like sum feed back on how they ride and about how fast they go. Thanks

Thu 07 Jul,2011 16:42

help me pleasemy cbr600fs been stood about 3year carbs been cleaned plugs changed plenty of spark everywhere bloke who did it reckons its running perfect on 2n4 but 1n3 are running cool with bit of misfire anybody got any ideas

Sat 18 Jun,2011 17:55

hi all, i'm new on just after some info what are the best tyres to fit on my cbr 600rr 07 model????

Mon 13 Jun,2011 14:06

thanks

Mon 13 Jun,2011 14:06

help anyone, i have a fireblade 93 model and my gearbox is knackered second gear mainly, im planning on putting a complete engine in it, anyone know what engines fit? im trying to get a 918 or 893 but does anyone know any other models that fit

Sun 12 Jun,2011 15:01

hey, bought my honda cbr600fx few months ago and realised that it was running KPH, and running 10mhp roughly below what the speedo was showing, iv bought a converter and fitted it, the KPH has changed to MPH on the ODOmeter, but the speedo showed 70mph on clock but i checked the sat nav said i was doin 91mph.

Sat 11 Jun,2011 20:27

With regards to midz question, had same trouble with my 93 model, took it to a good friend of mine. Took carbs off and found needles are not adjustable (no circlips). Put some washers under them to make it run a bit richer, took a bit of sorting to get it right, but it cured the problem

Sat 11 Jun,2011 12:05

Hi all, new to site so here goes, I am looking for a givi rack for my 1993CBR600 FP. Any one out there got one they don't need, or will a later 1998 model fit? Thanks

Fri 10 Jun,2011 15:07

hi, i have recently bought a cbr 900rrx 1999. the indicators dont work, they dont do anything when i switch them on. iv checked the fuse and its ok. iv been told to check the flasher relay but i cant find it anywere. does anyone no were it will be situated for this model. i will apprieciate any help

Thu 09 Jun,2011 20:25

hi i'm new here and looking for some advice. my oil light flashes on low revs.oli is to max mark. HELP

Tue 31 May,2011 15:17

hello i'm new here. i'm looking for a white smoke bubble for my 1996 cbr600 any one know where i get one?

Sat 28 May,2011 16:54

hi new to this site dose anybody know where i can get good priced decals for a 2004 954

Wed 18 May,2011 20:01

i have just put a second hand engine and gearbox in my cbr600 (done a sevice on it) and on the drive a heard noise coming from 4th gear then i realised that there was noise in every gear but when i put it in neutral the noise stop can anyone help PLEASE

Thu 12 May,2011 21:53

Hi All

I have an oil leak from my cbr600f rite under the no 1 cylinder from a small hole?? any ideas what this could be?? Help

Sun 08 May,2011 13:55

hi all, anyone know the best aftermarket screen for a cbr600f 1995 f3 pls

Tue 03 May,2011 14:27

Hi every1 , As member of university racing team we have to build a racing car using CBR 600 engine. Due to limitation of the design of car the Fuel pump has to external. Does anyone know the specification of the internal fuel pump of CBR 600 04, such as the pressure, and the flow rate? Many thanks

Tue 19 Apr,2011 22:40

Hi, i have a 600rr6 and the dash is going nuts! the right green indicator light has stopped working even though it lights up when you switch on the ignition. When you switch off the engine the rev needle sits at 2 then resets the dash and trip counter. does anyone have any idea what might be wrong?

Mon 11 Apr,2011 21:18

got cbr 600 fw rev counter started to go wild then stopped any ideas, is it a lose cable?

Sat 26 Mar,2011 23:12

hello

Wed 23 Mar,2011 23:28

Hi i have a 96 ft, and took it to main dealer to have carbs cleaned out and re balanced, now since i've got the bike back it feels like its not running freely. i.e when you roll off the throttle and back on there is a lag and juddering feeling that come's through the bike before it accelerates. The dealer say's that there is nothing wrong with the bike, ( they would though ) any ideas ??

Sun 20 Feb,2011 15:50

any1 got pics or fitted goodridge brake lines cbr600rr8????